Covering a car with film to prevent damage: rules and tips

A car’s body is constantly exposed to dust and small stones. The abrasive action of these particles is barely noticeable, but over time, they can cause scratches, which can damage the car’s appearance and lead to corrosion. To prevent this, a technology was developed for coating the car with a special polymer film. For this type of work, it is recommended to contact specialists, such as Car Services in Chicago.

Instructions for the work

The process is relatively simple, but it requires attention, a thorough approach, and care during the actual process. The following requirements must be met:

1. Choose the right type of film. Polyurethane film is available, designed for application to areas prone to damage. Vinyl film is less expensive and needs to be replaced every 2-3 years, but it provides protection against dust and sand and is easy to apply. Anti-gravel film can protect against flying stones and is recommended for localized application on the hood, bumper, sills, and wheel arches.
2. Work should only be performed in a protected, dust-free area. The car body is thoroughly washed and cleaned to ensure the absence of mechanical particles on the surface and to improve adhesion.
3. It is important to correctly cut the film to the correct dimensions for the car body elements. Allow a 3-4 cm margin around the edges to allow for folding and application to the back.
4. It is recommended to apply the film to a surface dampened with soapy water and then smooth it with a squeegee, removing liquid and air, creating a smooth surface without wrinkles or bubbles.

To begin, thoroughly wash and dry the car body, using Washes Chicago.

Tips

Begin work by selecting the appropriate film and considering the effect of abrasives on the car. Vinyl film can be used for less-damaged surfaces, while anti-gravel film is recommended for the most vulnerable ones.

Thoroughly wash the car body, degrease the surfaces, and avoid touching them with bare hands. Gloves are required for all work. Avoid touching the side of the film that will be applied to the car body. It will immediately lose some of its adhesive properties.

It is recommended to entrust this process to a specialist. The cost of their services will be recouped by the precision of the film application, savings in material and time for the customer, and the longevity of the protective coating.